Device is not ready for calibration

Meaning: 

Some device(s) is/are not ready so calibration cannot start. Some details are provided about which device(s) is/are affected

Troubleshooting Steps: 

Depending on the device(s) that have the issue.
To see the devices, go to 'View' > 'Show Connection Status'

• Actuator motor is turned off:
  
  • Go to Tools -> Enable motor
• Stage module is not parked - cannot start the indentation:
  • Park the profilometer - found in the 'Tools' tab
• Actuator, DAQ or Stage module are not ready:
  • Close CORSICA and turn off the PLX-Benchtop
  • Unplug and Replug all the cables from the PLX-Benchtop
  • Check the emergency stop is not activated 
  • Restart your PC
  • Turn on the PLX-Benchtop and check that power is going to the machine  

Contact support if the issue persists